Bath Screen Seal for ATMO 3-Panel Folding Screens - Clear

What this seal is

A clear soft-PVC channel seal best known as the replacement seal for ATMO 3-panel folding bath screens. It slots into the channel that runs along the bottom of the screen — no adhesive needed — and its flexible blade seals down onto the bath rim, so water stays in the bath even as the panels fold.

Over time the original seal hardens, discolours or splits and water starts creeping out under the screen. Sliding in a fresh seal restores a clean, watertight edge in minutes.

Choose your length

The seal is available in 1000mm or 2000mm lengths, with a custom cutting service if you would like it to arrive ready to fit. The soft PVC cuts easily with scissors, so if in doubt simply order the length above your screen width and trim it down at home.

Specification

Why fit this seal

Stops water escaping under the screen. A hardened or split bottom seal is the usual reason water pools on the bathroom floor beside the bath. A fresh seal protects flooring, skirting and plaster from long-term damage.

No adhesive, no mess. The seal simply slides into the existing channel along the bottom of the screen — no glue, no tools, and the old seal slides out just as easily.

Made for folding screens. The soft, flexible profile keeps sealing against the bath rim as the three panels fold and unfold, without dragging or tearing.

Easy replacement. Cut with household scissors and fitted in minutes — there is no simpler bathroom repair.

Fitting in three steps

1. Measure. Measure the width of your screen along the bottom edge, and check your old seal matches this profile.

2. Choose. Pick the 1000mm or 2000mm length at or above your screen width, or add custom cutting and it arrives ready to fit.

3. Fit. Slide the old seal out of the channel and clean the channel. Cut the new seal to the width of the screen with scissors, then slide it into the channel from one end until it is fully seated.

Not sure it fits?

If your screen is an ATMO 3-panel bath screen, this is the matching profile. For any other screen, email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will check it against the range and confirm the right profile before you order — usually the same working day.