Vertical Screen Seal for Bathstore Atlantes 850, Simpson & Crosswater

What this seal is

A clear semi-rigid vertical screen seal known to fit Bathstore Atlantes 850 bath screens and selected Simpson and Crosswater products. It combines soft PVC with a rigid PVC section: the rigid part keeps the seal straight and secure on the upright of the screen, while the soft part seals against the neighbouring panel to stop water escaping at the vertical edge.

Fitting is simple — the seal slides onto the upright of the screen from one end, with no adhesive or tools required. Because of the rigid section it is suitable for straight runs only.

Choose your length

Measure the height of the upright you need to seal, then pick the length at or above it — 900mm or 2000mm — and trim it down at home. Prefer it ready to fit? Choose a Custom Cut option and we'll cut it for you (please note custom-cut items are non-returnable).

Specification

Why fit this seal

Stops leaks at the vertical edge. A worn or missing vertical seal lets water escape between the screen and the adjacent panel every time you shower. A fresh seal closes the joint and protects flooring and skirting from water damage.

A known match for your screen. If your screen is an Atlantes 850 or one of the matching Simpson or Crosswater models, this is the profile — no guesswork comparing cross-sections.

No adhesive, no mess. The seal simply slides onto the upright, so it can be fitted or replaced without residue, sealant or drilling.

Easy DIY replacement. With the old seal off, the new one slides on in minutes — a five-minute job that makes the whole screen feel new again.

Fitting in three steps

1. Measure. Measure the height of the screen upright, and check your screen matches one of the known fitments — or compare the cutaway in the first photo with the end of your old seal.

2. Choose. Pick 900mm or 2000mm — whichever is at or above your screen height — or add the custom cutting service.

3. Fit. Slide the old seal off the upright and clean the fixing edge, cut the new seal to the screen height, then slide it on from one end until it sits fully seated.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day.