Bifold Shower Seal - 6mm T-Head, Low 7mm Profile, Seals 2-7mm Gaps

What this seal is

A low-profile clear channel seal for bifold and framed shower doors with a 6mm channel slot. The T-shaped head slides into the aluminium or plastic channel on the door — no adhesive needed — and the soft blade closes gaps of 2–7mm. At just 7mm overall it is the lowest of our 6mm T-head heights, made for doors that sit tight to the tray.

Fit it horizontally under the bottom rail of the door, or vertically between the glass and the wall, and it stops water escaping every time you shower.

Specification

Why fit this seal

Stops leaks under the door. A hardened or split bottom seal is the most common reason water ends up outside a bifold enclosure. A fresh seal closes the 2–7mm gap and keeps the water where it belongs.

Low profile, no drag. At only 7mm tall it suits doors sitting close to the tray, sealing the gap without catching or folding under the door.

No-mess fitting. The T-head simply slides along the existing channel — no adhesive, no tools, no drying time.

UK stock, fast dispatch. Held in stock in the UK and dispatched same working day when ordered before 2pm.

Fitting in three steps

1. Measure. Check the channel slot is 6mm wide, measure the gap you need to close (2–7mm) and the width of the door.

2. Choose. Pick the 1000mm or 2000mm length — whichever is at or above your door width — or have us custom cut it.

3. Fit. Slide the old seal out, clean the channel, cut the new seal to length, then feed the T-head in at one end and slide it across until flush.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will pick the right height from our 6mm T-head range before you order — usually the same working day.