Bifold Shower Seal - 7mm T-Head, Low 7mm Profile, Seals 2-7mm Gaps

What this seal is

A low-profile clear channel seal for bifold doors that sit close to the tray. The wide 7mm T-head slides into the channel in the door frame, and the body stands just 7mm tall — closing small gaps of 2–7mm without dragging on the tray or bath.

Fit it horizontally under the bottom rail of a bifold door, or vertically between a glass upright and the wall. No adhesive is needed — the T-head is held by the channel itself.

Check your size, then choose a length

Measure your gap first: this profile suits 2–7mm, while our taller 7mm T-head profiles cover 5–10mm and 7–12mm gaps. Then pick a 1000mm or 2000mm length (custom cut options available) at or just above your door width.

Specification

Why fit this seal

Made for tight clearances. On a door sitting just millimetres above the tray, a tall seal buckles and drags. This 7mm-high profile closes 2–7mm gaps while the door swings freely.

Stops leaks under the door. Even a few millimetres of open gap lets water track onto the bathroom floor — a fresh seal keeps flooring and skirting dry.

No adhesive, no mess. The T-head simply slides into the existing channel — and slides out again when it eventually needs replacing.

Cuts with scissors. Soft flexible PVC trims to an exact fit at home in seconds.

Fitting in three steps

1. Measure. Check the slot in your channel is around 7mm wide and the gap you need to close is between 2mm and 7mm.

2. Choose. Pick 1000mm or 2000mm — whichever is at or above your door width — or add the custom cut option.

3. Fit. Remove the old seal, clean the channel, cut the new seal to width, then feed the T-head in at one end and slide it along until seated.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm which 7mm T-head profile you need before you order — usually the same working day.