Push-In Bifold Shower Seal for 9-11mm Recess - Clear, 900mm & 2000mm

What this seal is

A clear, soft-PVC seal that pushes into a recess in the shower frame rather than sliding into a narrow slot. The 13mm-wide head compresses into recesses 9mm to 11mm wide and holds itself in place with no adhesive or tools.

Most customers fit it along the bottom horizontal rail of a bath screen or shower door, where it closes the gap and stops water dripping through; it works just as well vertically on glass uprights.

How to check it fits your door

Measure the open recess (groove) in your frame — if it’s 9mm, 10mm or 11mm wide, this seal will press in and grip. The first photo shows it seated in the rail with a cutaway of the exact profile.

Specification

Why fit this seal

Stops drips through the bottom rail. A perished push-in seal lets water track through the frame and onto the floor. A fresh seal presses in and closes the gap in minutes.

Self-gripping — no adhesive, no mess. The oversized 13mm head compresses into the 9–11mm recess and holds itself there. Nothing to glue, and it pulls out cleanly when next replaced.

Easy to cut at home. The soft PVC cuts with ordinary scissors, so trimming a 2000mm length down to your rail is quick and tidy.

UK stock, fast dispatch. Held in stock in the UK, so your replacement arrives quickly.

Fitting in three steps

1. Measure. Measure the width of the recess in your frame (it should be 9–11mm) and the length of the rail or upright you’re sealing.

2. Choose. Pick 900mm or 2000mm — whichever is at or above your measurement — or select a Custom Cut option for your exact length.

3. Fit. Pull the old seal out of the recess and clean out any residue, cut the new seal to length, then press the head into the recess along the full length, working from one end.

Not sure it fits?

Email a photo of your frame and old seal, or your measurements, to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and size before you order — usually the same working day.