Push-In Bifold Shower Seal for 7-9mm Recess - Clear

What this seal is

A clear soft-PVC bifold seal that pushes into a recess in your shower frame rather than sliding into a T-channel. The 9mm head compresses into frame openings 7mm to 9mm wide and grips on its own — no adhesive, no tools.

Most customers fit it along the bottom rail of a bath screen or shower door to stop water tracking underneath; it also works vertically between a glass upright and the tiles or wall.

Which recess size do I need?

Measure the open recess in your frame. If it is 7mm, 8mm or 9mm wide, this seal will press in and hold. Got a 9–11mm recess? We stock a larger version of this profile too — if you are between the two, compare the cutaway photo with the end of your old seal.

Specification

Why fit this seal

Stops leaks at the bottom of the door. A perished or missing bottom seal is the usual cause of water pooling outside a bath screen — a fresh seal protects flooring, skirting and plaster.

Push-fit, no mess. The head compresses into the recess and grips by itself, so there is no adhesive to apply and no residue when you next replace it.

Horizontal or vertical. The same profile seals under the bottom rail or up the side of the glass against tiles or a wall.

Cut to fit at home. Soft PVC trims cleanly with scissors — order the next length up and cut it to your door.

Fitting in three steps

1. Measure. Check the open recess in your frame is 7–9mm wide, and measure the length of the run you need to seal.

2. Choose. Pick the 1000mm or 2000mm length at or above that measurement, or have us custom cut it.

3. Fit. Pull the old seal from the recess, clean out any residue, cut the new seal to length and press the head into the recess along the full run.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and size before you order — usually the same working day.