Glass-Grip Bifold Screen Seal for 4mm, 5mm & 6mm Glass - Clear

What this seal is

A clear soft-PVC bifold screen seal that needs no frame channel at all — the channel section grips directly onto the edge of 4mm, 5mm or 6mm glass with no adhesive, and the fin beneath seals gaps of 1–3mm.

Because the material is soft and flexible, it follows curved glass just as happily as straight panels — ideal for curved bifold and sliding screens where rigid seals will not bend.

Choose your length

Two lengths are available — 900mm and 2000mm. Pick the length at or just above the width (or height) of your panel; the soft PVC cuts easily with scissors, or add our custom cutting service and it arrives ready to fit.

Specification

Why fit this seal

No channel needed. Many bifold screens have no frame channel to slot a T-head seal into — this profile grips the glass edge itself, so there is nothing extra to fit or measure.

Follows curved glass. The soft PVC flexes around curved panels as easily as straight ones, keeping a continuous seal along the whole edge.

Stops splashes at the bottom edge. The fin closes 1–3mm gaps beneath the panel, keeping water inside the enclosure and off the bathroom floor.

Cuts with scissors. Trim it to the exact width or height of your panel in seconds — no saws or special tools.

Fitting in three steps

1. Measure. Check your glass is 4–6mm thick and the gap beneath it is 1–3mm — no channel measurements needed.

2. Choose. Pick 900mm or 2000mm at or above your panel width or height.

3. Fit. Pull the old seal off the glass edge, clean the glass, cut the new seal to size, then push the channel onto the glass edge, working along its length.

Not sure it fits?

Email a photo of your old seal or your screen edge to sales@industrial-polymers.co.uk and our UK team will confirm the right profile before you order — usually the same working day. If your gap is bigger than 3mm, we'll point you to one of our taller-bladed seals instead.