Frame Seal for 10mm Glass - Glass to Frame Strip, 900mm & 2m

What this seal is

A clear frame seal for 10mm glass. Made from soft, flexible PVC — similar in feel to silicone or rubber — it wraps around the edge of the glass before the panel is inserted into your frame. Once fitted, it supports the glass within the frame and protects it from any damage the aluminium frame could otherwise cause.

Seals like this are commonly found along the bottom horizontal section of a bath screen or shower door, and can also be used vertically on the upright of the glass to seal between the glass and the frame.

Choose your length

Measure the edge of the glass you are sealing and pick the nearest length at or above it — 900mm or 2000mm. If your measurement sits between the two, choose the 2000mm length and trim it down, or add our custom cutting service and it arrives ready to fit.

Specification

Why fit this seal

Protects your glass. A cushioning layer between 10mm glass and the aluminium frame prevents the chips, scratches and stress points that metal-on-glass contact can cause.

Supports the panel in the frame. The soft PVC takes up the tolerance between glass and frame, holding the panel firmly and evenly along its length.

Durable yet flexible. The high-quality soft PVC stays flexible in daily use, sealing between glass and frame without going brittle.

Easy to cut at home. The soft material trims cleanly with a good pair of scissors, so getting an exact fit takes minutes.

Fitting in three steps

1. Measure. Check your glass is 10mm thick and measure the edge of the glass where the seal will sit.

2. Choose. Pick the nearest length at or above your measurement — 900mm or 2000mm.

3. Fit. Remove the old seal from the gap between your glass and the frame, trim the new seal to size and push it into the gap.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day.