Interlocking EVA Barefoot Pool Tiles

Interlocking EVA tiles for barefoot wet areas where drainage, underfoot comfort and straightforward maintenance are required. Each moulded tile has a textured walking surface, drainage slots and integral feet that hold the surface 15 mm above the substrate so water can pass beneath the installation.

Select the correct component

• Tile box: 27 tiles, each 330 × 330 × 15 mm, covering 2.94 m².
• Ramped edge: one 70 × 330 mm EVA edging piece for an exposed tile edge.

Tile boxes and ramped edges are separate variants. Select the component required before adding the product to the basket.

Material and performance

Typical applications

Suitable for pool surrounds, changing rooms, communal shower areas, spa circulation routes and other indoor barefoot wet areas, subject to site-specific slip, drainage and cleaning requirements.

Quantity planning

Measure the finished floor area in square metres, divide by 2.94 and round up to the next full box. Allow separately for cuts, layout waste and spare tiles. For exposed edges, measure the actual perimeter run and allow approximately three 330 mm edging pieces per linear metre.

Installation guidance

• Lay on a stable, clean substrate with effective falls and drainage.
• Plan the 330 mm module before cutting around walls, columns, benches and gullies.
• Keep drainage outlets accessible and use ramped edging where exposed edges are crossed.
• Confirm compatibility with site cleaning chemicals before routine use.

Cleaning and maintenance

Clean the walking surface using a method and detergent suitable for EVA. Lift sections periodically to remove debris from the substrate and drainage void, then rinse and relay once the area is clean.

Supply: the selected tile-box or ramped-edge variant only.