Black Magnetic Shower Seals - 8-10mm Glass, 1 Pair, 90/180

What this seal is

A pair of black magnetic seals for shower doors with 8–10mm glass. Each rigid PVC U-section pushes onto a glass edge — no adhesive needed — and carries a black magnetic strip to match the rest of your enclosure. The magnets pull the door closed and hold it shut while you shower, yet release easily when you're finished.

They fit vertically, most commonly on quadrant enclosures, though some bath screens and other doors use them too, and can meet at either 90° or 180° as shown in the main product image.

Which doors do they suit?

Using the seals at 180° on sliding doors, they're suitable as long as the gap between the two panes is no greater than 27mm when the doors are closed. At 180° on hinged or pivoting doors the gap needs to be exactly 27mm — otherwise the two magnetic strips won't quite line up and the seals may not close as intended.

Specification

Why fit these seals

Stops leaks at the door meeting point. The junction where two doors meet is a prime escape route for water — magnetic seals pull the doors together into a positive, watertight closure.

Holds the door properly shut. The magnets keep the door closed for the whole shower, yet part with a gentle push when you're done.

Matches dark enclosures. The all-black profile and magnet strip keep the lines of a black-framed enclosure consistent where a clear or white seal would stand out.

No adhesive, no mess. Each U-section grips 8–10mm glass on its own — they push straight on and come off cleanly when it's time to replace them.

Fitting in three steps

1. Measure. Check your glass is 8–10mm thick, measure the height of the door edges, and — if using at 180° — check the closed-door gap against the 27mm guidance above.

2. Choose. Pick 2000mm or 2500mm — whichever is at or above your door height — or use the custom cut option.

3. Fit. Trim both seals to length, then push each seal onto its glass edge from one end and work your way along, with the magnetic strips facing so they attract when the door closes. Never slide a seal along the glass — this can damage it.

Not sure they fit?

Email a photo of your old seals or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day.