Magnetic Shower Seals - 8mm Glass, 135 or 180, Spans 27mm

What this seal is

A pair of clear magnetic seals for shower doors with 8mm glass. Each rigid PVC U-section pushes onto a glass edge — no adhesive needed — and carries a magnetic strip covered in white plastic to match the rest of your enclosure. The magnets pull the door closed and hold it shut while you shower, yet release easily when you’re finished.

They fit vertically, most commonly on quadrant enclosures, though some bath screens and other doors use them too, and can meet at either 135° or 180° as shown in the main product image.

Which doors do they suit?

On sliding doors, the seals are suitable as long as the gap between the two panes is no greater than 27mm when the doors are closed. On hinged or pivoting doors the gap needs to be exactly 27mm — otherwise the two magnetic strips won’t quite line up and the seals may not close as intended.

Specification

Why fit these seals

Stops leaks at the door meeting point. The junction where two doors meet is a prime escape route for water — magnetic seals pull the doors together into a positive, watertight closure.

Holds the door properly shut. The magnets keep the door closed for the whole shower, yet part with a gentle push when you’re done.

No adhesive, no mess. Each U-section grips the 8mm glass on its own — they push straight on and come off cleanly when it’s time to replace them.

Blends with your enclosure. Clear PVC with a white-covered magnet keeps the seals discreet against glass and white frames alike.

Fitting in three steps

1. Measure. Check your glass is 8mm thick, measure the height of the door edges, and check the gap between the closed doors against the 27mm guidance above.

2. Choose. Pick 2000mm or 2500mm — whichever is at or above your door height — or use the custom cut option.

3. Fit. Trim both seals to length, then push one onto each meeting edge with the magnetic strips facing so they attract when the door closes. No tools, no adhesive.

Not sure they fit?

Email a photo of your old seals or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day.