Self-Adhesive Magnetic Seals - 27 x 6mm, Angled or Straight

What this seal is

A pair of self-adhesive magnetic shower seals with high-quality 3M VHB double-sided tape already applied to the back of each magnet. They stick to any suitably flat surface — glass, tiles and more — so you can add a magnetic closure to a shower door even where there's no channel to clip a conventional seal into.

Each magnetic strip is covered in white plastic to match the rest of your enclosure. Fitted facing each other, the two strips pull together to hold the door shut while you shower, yet part easily when you push the door open.

Specification

Why fit this seal

Holds the door properly shut. The paired magnets pull the door closed and keep it there while you shower, stopping it drifting open and letting water out.

No channel needed. Because the fixing is self-adhesive rather than push-fit, this pair works on doors and panels that have nowhere to clip a conventional seal.

No-mess fitting. The 3M VHB tape is already on the seal — peel and press, with no wet adhesives or drilling.

Blends in. The white plastic covering over the magnets matches typical enclosure frames for a tidy finish.

Fitting in three steps

1. Measure. Measure the height of the closing edges where the two seals will meet.

2. Choose. Trim each 2000mm seal to length with garden secateurs or a junior hacksaw, or use our custom cutting service.

3. Fit. Make sure both surfaces are flat, clean and dry, peel the backing from the 3M tape and press each seal firmly into place so the magnets meet when the door closes.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right seal before you order — usually the same working day.