Shower Enclosure Door Handle Knob Chrome - Length of 200mm

What this handle is

A stylish chrome-effect replacement handle and knob for shower enclosure doors, 200mm long and made for doors drilled at 125mm between hole centres. It screws straight onto the existing holes in the glass — simply unscrew your old handle and screw this one on in minutes.

The knob sits on the inside of the door so the door opens easily from inside the shower, and two glass protection washers are included to keep metal away from glass.

Specification

Why fit this handle

Instant refresh for a tired door. A pitted or wobbly handle makes a whole enclosure feel worn — a bright chrome-effect replacement smartens it up in minutes.

Fits in minutes, no drilling. It uses your door’s existing holes: unscrew the old handle, screw the new one on, done.

Kind to your glass. The two included protection washers cushion the fixing points so the metal never bears directly on the glass.

Easy to use from both sides. The full handle on the outside and the knob on the inside make the door easy to open whichever side you’re on.

Fitting in three steps

1. Measure. Check the distance between the centres of the two holes in your glass is 125mm, and that each hole is at least 6mm in diameter (the fixing bolt is 5.5mm).

2. Remove. Unscrew and lift off your old handle, keeping hold of the door while you work.

3. Fit. Position a protection washer at each fixing point, then screw the new handle and knob together through the glass until snug — don’t overtighten.

Not sure it fits?

Email a photo of your old handle or your measurements — especially the distance between hole centres — to sales@industrial-polymers.co.uk and our UK team will confirm it’s the right fit before you order — usually the same working day.