Shower Enclosure Door Handle Knob Chrome - Length of 220mm

What this handle is

A stylish chrome-effect replacement handle and knob for shower enclosure doors, 220mm long. It's an ideal like-for-like swap for any glass door drilled with 145mm between hole centres — simply unscrew your old handle and screw this one on in minutes, no new holes and no glass work required.

The set includes a knob for the inside face of the door, so you can open the shower door easily from the inside, plus two glass protection washers to cushion the fittings against the glass.

Will it fit my door?

Two measurements decide it: the distance between the centres of the two holes in your glass must be 145mm, and each hole must be at least 6mm in diameter, as the fixing bolt measures 5.5mm across. Both are easy to check with a tape measure before you order.

Specification

Why fit this handle

Instant refresh. A corroded or broken handle makes a whole enclosure look tired — a new chrome-effect handle smartens it up in minutes for a fraction of the cost of a new door.

No drilling, no glass risk. It uses the holes already in your door, and the included protection washers keep metal off glass when you tighten it up.

Works from both sides. The full handle sits outside and the knob inside, so the door opens easily whichever side you're on.

Simple DIY job. If you can use a screwdriver, you can fit this — unscrew the old, screw on the new, done.

Fitting

1. Measure. Check the distance between your hole centres is 145mm and the holes are at least 6mm in diameter.

2. Remove. Unscrew your old handle and knob and lift them away from the glass.

3. Fit. Place a protection washer each side of the glass, offer up the new handle and knob, and screw them together through the existing holes. Hand-tight is enough — done in minutes.

Not sure it fits?

Email a photo of your old handle or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right handle before you order — usually the same working day.