Bath Screen Seal - 4-6mm Glass, Deflector Ramp

What this seal is

A clear replacement seal for shower and bath screens with 4mm, 5mm or 6mm glass. The rigid PVC U-section pushes straight onto the edge of the glass with no additional adhesive. It was designed to fit some specific Matki Radiance doors, but may also fit screens and doors from other manufacturers.

Previous customers have indicated that this seal fits Matki Radiance doors with one of these codes: NRI1200, NRP700, NRP760, NRP800, NRP900, NRPC700, NRPC760, NRPC800, NRPC900, NRPC9076, NRPC9080, NRIC1280 or NRIC1290. Seals like this are most commonly found along the bottom horizontal edge of a bath screen or shower door, and work just as well vertically on the upright of the glass to seal against the tiles or wall.

Choose your length

Measure the edge of the glass you are sealing and pick the nearest length at or above it — 800mm, 900mm, 1400mm or 2000mm. If your measurement sits between two lengths, choose the longer one and trim it down, or add our custom cutting service and it arrives ready to fit.

Specification

Why fit this seal

Keeps your Matki door watertight. A worn or missing seal is the most common cause of water pooling outside the shower — replacing it takes minutes and protects flooring, skirting and plaster from long-term damage.

Made-to-fit replacement. Matched by previous customers to a wide range of Matki Radiance door codes, so you can replace the original seal without replacing the door.

No adhesive, no mess. The U-section grips 4–6mm glass on its own, so it pushes straight on and can be removed later without leaving residue on the glass.

Cut to fit at home. Order the next length up and trim it down for a perfect edge-to-edge fit, or use our custom cutting service.

Fitting in three steps

1. Measure. Check your glass is 4–6mm thick and, if you have a Matki Radiance door, check its code against the list above.

2. Choose. Pick the nearest length at or above the edge you are sealing.

3. Fit. Remove the old seal, clean the glass edge, trim the new seal to size and push the U-section onto the edge of the glass.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day.