Shower Screen Seal - 4-6mm Glass, Twin Angled Blades

What this seal is

A clear deflector seal for shower and bath screens with 4–6mm glass. The rigid PVC U-channel pushes straight onto the bottom edge of the glass — no adhesive, no tools — and works together with the upstand or threshold of your tray or bath, deflecting splashing water back inside the shower rather than physically sealing a gap.

If water is escaping over the threshold at the bottom of your screen and the old seal has discoloured, split or gone missing, this is the simple like-for-like replacement: it slides on in seconds and trims to the exact width of your glass at home.

Specification

Why fit this seal

Protects your bathroom floor. Splashes that clear the threshold soak flooring, skirting and plaster over time. A fresh deflector seal sends that water straight back into the tray.

No adhesive, no mess. The U-channel grips 4–6mm glass on its own — it pushes straight on and comes off again without leaving residue.

Easy replacement. A tired, discoloured strip along the bottom of the screen makes the whole enclosure look old. Swapping it takes minutes and costs a fraction of a new screen.

UK stock, fast dispatch. Held in stock in the UK and dispatched the same working day when you order before 2pm.

Fitting in three steps

1. Measure. Check your glass is 4–6mm thick and measure the width of the screen's bottom edge.

2. Choose. Pick the nearest length at or above that width — or use our custom cutting service and it arrives ready to fit.

3. Fit. Trim to length if needed, then push the channel onto the bottom edge of the glass so the seal sits against your upstand or threshold. No adhesive, no drying time.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day.