Shower Screen Seal - 6-8mm Glass, Seals 5-15mm Gaps

What this seal is

A clear shower screen seal for 6–8mm glass that closes gaps of 5mm to 15mm. The rigid PVC U-section pushes straight onto the edge of the glass — no adhesive, screws or drilling — and the flexible section bridges the gap between your screen and the bath, tray, tiles or wall, stopping water escaping every time you shower.

It's most commonly fitted along the bottom horizontal edge of a bath screen or shower door, but works just as well vertically on the upright of the glass, sealing against tiles or a wall.

Choose your length

This seal comes in 800mm, 900mm, 1400mm or 2000mm lengths. Pick the length at or above the edge you're sealing — it cuts down easily at home, or use our custom cutting service and it arrives ready to fit.

Specification

Why fit this seal

Stops leaks instantly. A worn, discoloured or missing screen seal is the most common cause of water pooling outside the shower. Replacing it takes minutes and protects flooring, skirting and plaster from long-term water damage.

No adhesive, no mess. The channel grips 6–8mm glass on its own — it slides straight on and can be removed or repositioned without leaving residue on the glass.

Wide gap range. One profile covers anything from 5mm right up to 15mm, so even a slightly uneven gap along the edge is sealed neatly — and the clear PVC is barely visible once fitted.

Cut to fit at home. Order the next length up and trim it down for a perfect edge-to-edge fit, or use our custom cutting service and it arrives ready to fit.

Fitting in three steps

1. Measure. Check your glass is 6–8mm thick, measure the edge of the glass, and measure the gap you need to close — it should sit between 5mm and 15mm.

2. Choose. Pick the nearest length at or above your measurement.

3. Fit. Trim to length if needed, then push the channel onto the edge of the glass so the seal faces the gap. Done — no tools, no adhesive, no drying time.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day.