Shower Screen Seal - 8-10mm Glass, Twin Fin, 12mm

What this seal is

A clear bottom seal for shower doors and bath screens with 8mm, 9mm or 10mm glass. The rigid PVC channel pushes onto the edge of the glass — no adhesive needed — and the flexible fin closes gaps of 7mm to 12mm between the glass and the tray, bath or wall, stopping water escaping every time you shower.

It's most often fitted horizontally along the bottom edge of a bath screen or shower door, but works just as well vertically on the upright of the glass to seal against the tiles or wall.

Specification

Why fit this seal

Stops leaks instantly. A worn, discoloured or missing bottom seal is the most common cause of water pooling outside the shower — replacing it takes minutes and protects flooring, skirting and plaster.

No adhesive, no mess. The channel grips 8–10mm glass on its own; it slides straight on and comes off again without leaving residue.

Covers the everyday gap range. The 7–12mm fin suits the door-to-tray gap found on a great many screens and doors with thicker glass.

Cut to fit at home. Order the next length up and trim it down for an edge-to-edge fit, or use our custom cutting service and it arrives ready to fit.

Fitting in three steps

1. Measure. Check your glass is 8–10mm thick and measure the gap you need to close — this profile suits 7–12mm.

2. Choose. Pick the nearest length at or above your glass edge — 800mm, 900mm, 1400mm or 2000mm.

3. Fit. Trim to length if needed, then push the channel onto the edge of the glass with the fin facing the gap. No tools, no adhesive, no drying time.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day.