Shower Screen Seal - 6-8mm Glass, Seals 5-10mm Gaps

What this seal is

A clear push-fit seal for shower doors and bath screens with 6–8mm glass. The rigid PVC U-section — about 11mm tall, with a 6mm mouth widening to an 8mm base — grips the edge of the glass on its own with no adhesive or screws. A soft 9mm deflector fin angles up against the glass face, and twin 10mm blades hang below to close gaps of 5mm to 10mm, stopping water escaping onto the bathroom floor.

It is most commonly fitted along the bottom horizontal edge of a bath screen or shower door, and works just as well vertically on the glass upright to seal the gap between the glass and the tiles or wall.

Specification

Why fit this seal

Stops leaks and protects floors. A worn, discoloured or missing seal is the most common cause of water pooling outside the shower. Replacing it takes minutes and protects flooring, skirting and plaster from water damage.

No adhesive, no mess. The channel grips 6–8mm glass on its own — it pushes straight on and comes off again without leaving residue on the glass.

Neat, close seal. The twin blades close gaps from 5mm up to 10mm, and the clear PVC is barely visible once fitted.

UK stock, fast dispatch. Held in stock in the UK and dispatched same working day when ordered before 2pm.

Fitting in three steps

1. Measure. Check your glass is 6–8mm thick, measure the edge to be sealed and the gap you need to close (5–10mm).

2. Choose. Pick the nearest length at or above your measurement — 800mm, 900mm, 1400mm or 2000mm.

3. Fit. Trim to length if needed, then push the seal onto the glass from one end and work your way along. Do not slide the seal along the glass, as this can damage it.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and size before you order — usually the same working day. Got curved glass? We can curve this seal to your measurements — just get in touch and we'll send you our simple measuring guide.