Shower Screen Seal for Provex Screens - Rigid-Top, Clear

What this seal is

A clear replacement seal best known for fitting Provex shower screens. The rigid top section slides into the frame and seats firmly, while the soft PVC body below does the sealing. Because the top is rigid it holds its line along the frame and won't creep out of position — but it isn't flexible, so it suits straight runs only.

If your Provex screen is leaking or its original seal has yellowed, split or fallen out, this is the like-for-like replacement: slide the old one out, slide this one in.

Specification

Why fit this seal

The right profile for Provex. Tracking down a seal for a branded screen is the hard part — this profile is the known match for various Provex screens, so the replacement actually fits.

Stays put. The rigid top seats firmly in the frame and holds the seal straight along the full run, with no sagging or creeping over time.

No adhesive, no mess. It slides into the existing frame channel — no glue, no residue, and the next replacement slides in just as easily.

UK stock, fast dispatch. Held in stock in the UK and dispatched same day when you order before 2pm.

Fitting in three steps

1. Measure. Measure the length of the run to be sealed, and compare the cutaway in the first photo with the end of your old seal to confirm the profile.

2. Choose. Pick 900mm or 2000mm — whichever is at or above your measurement — or use our custom cutting service and it arrives ready to fit.

3. Fit. Slide the old seal out of the frame and clean the channel. Cut the new seal to length with secateurs or a fine-tooth saw, then slide the rigid top section into the frame until seated end to end.

Not sure it fits?

Email a photo of your old seal's end profile or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile before you order — usually the same working day.