White Magnetic Seals - M-Shaped Head, Spans 22mm - 1 Pair

What these seals are

A pair of white magnetic channel seals for shower doors. Each seal has an “M”-shaped top that slides into a corresponding M-shaped channel on your enclosure, and a magnetic strip covered in white plastic to match the rest of the frame. The magnets pull the door closed and hold it shut while you shower, yet release easily when you push the door open.

They fit vertically and are usually found on quadrant enclosures, although some bath screens and other doors use them too. Used together as a pair they will span a maximum gap of 22mm; if you are pairing one with a different seal, check the full dimensions on the technical drawing in the gallery.

Specification

Why fit these seals

Holds the door properly shut. The magnetic strips pull the closing edges together and keep them sealed while you shower — no drips through a door that drifts open — yet the door still opens with an easy push.

Matches your enclosure. The white plastic covering blends with white-framed enclosures instead of standing out against them.

Complete pair supplied. Both sides of the closing edge are covered in one order — two 2000mm lengths, ready to fit.

Easy to cut at home. The soft PVC trims cleanly with a good pair of scissors, so cutting down to your door height takes minutes.

Fitting in three steps

1. Measure. Check your enclosure has M-shaped channels and measure the height of the door edge; used together the pair spans a gap of up to 22mm.

2. Choose. Order the 2000mm pair and plan to trim to height, or add our custom cutting service and they arrive ready to fit.

3. Fit. Remove the old seals from the channels, clean the channels to remove any dirt or grime, then slide each new seal along the length of its channel.

Not sure they fit?

Email a photo of your old seals or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile before you order — usually the same working day.