Magnetic Shower Seals - 8-10mm Glass, 90 or 180, Spans 27mm

What these seals are

A pair of magnetic shower screen seals for 8–10mm glass. Each rigid PVC U-section pushes straight onto the edge of the glass with no adhesive, and carries a magnetic strip covered in white plastic to match the rest of your enclosure. The magnets pull the door firmly shut while you shower, yet still release easily when you push the door open.

They are fitted vertically, usually on quadrant enclosures, though some bath screens and other doors use them too — and the pair can meet at either 90° or 180°, as shown in the main product image.

Which angle and gap do I have?

At 90° the seals close the corner where two glass panels meet. At 180° with sliding doors, the seals suit any gap up to 27mm when the doors are closed. At 180° with hinged or pivoting doors, your gap needs to be exactly 27mm — otherwise the two magnetic strips will not quite line up and the seals may not function as intended.

Specification

Why fit these seals

Holds the door properly shut. Worn magnetic seals let a door drift open mid-shower and leak. A fresh magnetic pair snaps the door closed every time and keeps water off your bathroom floor.

Easy to open, secure when closed. The magnetic strips grip firmly while you shower but release with a gentle push once you are finished.

No adhesive, no mess. Each U-section grips 8–10mm glass on its own — the seals slide straight onto the door edges and can be removed without leaving residue.

One pair, two layouts. The same pair works on a 90° corner or a 180° in-line opening, so it suits quadrant enclosures, bath screens and other doors alike.

Fitting in three steps

1. Measure. Check your glass is 8–10mm thick, note whether your seals meet at 90° or 180°, and measure the gap between the closing edges and the height of the door edge.

2. Choose. Confirm your gap suits your door type (up to 27mm for sliding at 180°, exactly 27mm for hinged at 180°), then pick the 2000mm or 2500mm pair.

3. Fit. Trim to length if needed, then push a seal onto each closing edge of the glass so the magnetic strips meet squarely when the door closes. No tools, no adhesive, no drying time.

Not sure they fit?

Email a photo of your old seals or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile, angle and length before you order — usually the same working day.