Magnetic Shower Seals - 6-8mm Glass, 90 or 180, Spans 23mm

What this seal is

A pair of clear magnetic shower screen seals for 6–8mm glass. Each rigid PVC U-channel simply pushes onto the edge of the glass — no adhesive needed — and carries a magnetic strip covered in white plastic to match the rest of your enclosure. When the door closes, the two strips pull together and hold it firmly shut while you shower, yet still release easily when you push the door open.

These seals fit vertically on the closing edges of the door, most commonly on quadrant enclosures, though many bath screens and other doors use them too. They can be used at either 90° or 180°.

Check your gap and door type

If you have sliding doors, these seals are suitable as long as the gap is no greater than 23mm when the doors are closed. If you have hinged or pivoting doors and are using the seals at 180°, the gap needs to be exactly 23mm — otherwise the two magnetic strips will not quite line up and the seals may not function as intended.

Specification

Why fit this seal

Holds the door securely shut. The magnetic strips pull the door closed and keep it sealed while you shower — no more door drifting open and water escaping onto the floor.

Blends in with your enclosure. The clear channel and white-covered magnetic strip match the look of most enclosures, so the replacement is barely noticeable.

No adhesive, no mess. The channels grip 6–8mm glass on their own — they push straight on and can be removed without residue.

UK stock, fast dispatch. Order before 2pm and your seals are dispatched the same working day.

Fitting in three steps

1. Measure. Check your glass is 6–8mm thick, measure the door height, and check the gap between the closing edges as described above.

2. Choose. Pick the 2000mm or 2500mm pair — whichever is at or above your door height.

3. Fit. Trim both seals to length if needed, then push a channel onto each closing edge so the magnetic strips face each other. Close the door to check they meet squarely.

Not sure it fits?

Email a photo of your old seals or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and size before you order — usually the same working day.