Shower Screen Seal - 6-8mm Glass, Seals 22-26mm Gaps

What this seal is

A clear replacement shower screen seal for 6–8mm glass, sealing gaps of 22mm to 26mm. The high-quality rigid PVC U-section simply pushes onto the edge of the glass — no additional adhesive needed — and bridges the wide gap between your screen and the tray, tiles or wall.

This profile is most commonly fitted along the bottom horizontal edge of a bath screen or shower door, and works just as well vertically on the upright of the glass to seal against the wall or tiles. It is a straight seal, designed for straight glass only.

Choose your length

Available in 800mm, 900mm, 1400mm or 2000mm lengths. Measure the edge of glass you need to cover and pick the nearest length at or above it — the seal is easily cut down to size at home, or use our custom cutting service and it arrives ready to fit.

Specification

Why fit this seal

Closes very wide gaps. Most bottom seals only bridge a few millimetres — this profile is made for screens sitting 22–26mm off the tray or wall, where a standard seal would leave daylight and drips.

Stops leaks and protects your bathroom. A worn or missing seal lets water track onto the floor every time you shower — replacing it takes minutes and protects flooring, skirting and plaster from long-term damage.

No adhesive, no mess. The rigid PVC channel grips 6–8mm glass on its own, so there is nothing to stick, cure or clean up — and it can be removed without leaving residue.

Barely visible once fitted. The clear PVC blends into the glass for a neat, discreet finish.

Fitting in three steps

1. Measure. Check your glass is 6–8mm thick, measure the gap you need to close (22–26mm for this profile) and the length of the glass edge.

2. Choose. Pick the nearest length at or above your measurement — or add custom cutting and we'll trim it for you.

3. Fit. Trim to length if needed, then push the seal onto the glass starting at one end and work your way along, pressing it on as you go rather than sliding it.

Not sure it fits?

Email a photo of your old seal or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile and length before you order — usually the same working day. Got curved glass? We can quote to curve this seal (or a similar profile) to your measurements — just get in touch and we'll send you our simple measuring guide.