Vertical Shower Seal Pair - 8-10mm Glass, Fins 8-35mm

What this seal is

A pair of vertical seals for sliding shower doors with 8–10mm glass. Each rigid PVC U-section pushes straight onto the edge of the glass — no adhesive required — and the soft side fin closes the gap between the fixed panel and the sliding door, stopping water escaping every time you shower.

These seals are normally used vertically on sliding doors, either on their own or as a pair. If your existing fin is partially rigid and partially soft, these seals should still work fine.

Choose the right fin depth

The soft fin is available in depths of 8mm, 15mm, 20mm, 25mm, 30mm or 35mm. Measure the gap you need to close and pick the fin depth that covers it — if your gap sits between two sizes, choose the larger fin, as the flexible blade compresses to give a tighter seal.

Specification

Why fit this seal

Stops leaks on sliding doors. Worn vertical seals are the usual reason water finds its way out between a sliding door and its fixed panel — a fresh pair closes the gap and protects your flooring and skirting.

No adhesive, no mess. The U-sections grip 8–10mm glass on their own, so they push straight on and come off cleanly whenever they need replacing.

Six fin depths, three finishes. With fins from 8mm to 35mm and a choice of Clear, Chrome or Black, you can match both your gap and the look of your enclosure.

Cut to fit at home. The 2m and 2.5m lengths trim down easily to your door height, or use our custom cutting service and they arrive ready to fit.

Fitting in three steps

1. Measure. Check your glass is 8–10mm thick, measure the height of the door edges, and measure the gap you need to close.

2. Choose. Pick the fin depth that covers your gap, your finish, and either the 2000mm or 2500mm length.

3. Fit. Trim to length if needed, then push each U-section onto its vertical glass edge so the fins close the gap between the door and the fixed panel. No tools, no adhesive.

Not sure it fits?

Email a photo of your old seals or your measurements to sales@industrial-polymers.co.uk and our UK team will confirm the right profile, fin depth and length before you order — usually the same working day. We also stock a range of magnetic seals often found on the same types of enclosure — send us end-on photos of your existing magnetic seals and we can advise.