
Rubber & FoamSKU IP-PME-10-BLACK
PVC Mat Edging Strip – 10mm Low Profile – 10.1m Roll
This 10mm PVC mat edging strip is a 50mm wide ramped border that bonds to the edge of 10mm thick matting, giving a gentle slope down to the floor so people and trolleys do not catch the mat edge. It is sold as a single 10.1m roll, in black or dark grey.
At a glance
- Low profile PVC ramp edge for 10mm thick mats
- 50mm wide ramp from floor level up to 10mm
- One 10.1m roll per order quantity
- Black or dark grey to match or contrast with the mat
- Bonds to the mat with cold weld paste for a permanent, trip-free join
- Cuts cleanly with a sharp knife for mitred corners
Typical uses
- Ramped edges on 10mm anti-slip wet-area and pool-side matting
- Finishing loose-lay workplace matting at walkways and doorways
- Reducing trip hazards where matting meets bare floor
- Neat borders on matting cut to size on site
Which one do I need?
| Mat 10mm thick | This 10mm low profile mat edging strip |
| Mat 14mm thick | Choose our 14mm mat edging strip, which rises to the taller mat edge |
| Edge seen by visitors | Dark grey softens the edge; black blends with black matting |
Technical drawing
Specification
| Material | PVC |
| Height at mat edge | 10mm |
| Width | 50mm |
| Roll length | 10.1m |
| Unit of sale | One roll |
| Colours | Black, dark grey |
| Fixing | Cold weld paste (about one 132g tube per roll) |
How much do I need?
Measure every mat edge that will be exposed to foot or wheeled traffic. Example: a 3m x 2m mat with all four sides open needs 3 + 3 + 2 + 2 = 10m, so one 10.1m roll covers it, with one tube of cold weld paste. If the mat sits against a wall on one long side, you need 7m. Allow a little extra for mitred corners.
Fitting tips
- Cut the mat edge straight and clean, and make sure both faces are dry and free of dust or grease.
- Run the cold weld paste evenly along the full joint so there are no weak spots.
- Press the edging tight against the mat, keep it straight, and let the paste cure before allowing traffic.
- Mitre corners at 45 degrees for a neat, continuous border.
Complete your project
- Ribbed PVC Workplace Matting – 3mm, 20m x 1m Roll
- Open Grid Non-Slip Matting – Anti-Fatigue Drainage Mat for Wet Areas
- Industrial Rubber Cable Protector – 140mm x 36mm
Questions
How is this mat edging supplied?
Each unit is one 10.1m roll of 10mm low profile PVC mat edging strip in the colour you choose.
How does it attach to the mat?
It is bonded to the mat edge with cold weld paste. It does not clip on, so a clean, dry joint matters.
How much cold weld paste do I need?
Allow about one 132g tube for every 10.1m roll of edging.
Which mats does it suit?
Mats around 10mm thick, such as anti-slip wet-area and pool-side matting. For 14mm mats, use the 14mm edging strip.
Can I use it to finish cut-to-size matting?
Yes. It is designed to give site-cut mats a neat, ramped, trip-free edge.
Need help matching edging to your matting? Contact our team.
Product details
| SKU | IP-PME-10-BLACK |
|---|
More from this range
Request a quote
Fast, no-obligation price from our UK team for:PVC Mat Edging Strip – 10mm Low Profile – 10.1m Roll